Mediacom HD Digital Adapter Betriebsanweisung PDF herunterladen (Seite 4)

DCX700 High-Definition Digital Set-Top Box • User Guide

365-095-14284 x.1

VENTILATE

inch space

inch

POWER

LAN REC

DATA

DCX700 M-

During Installation

• Do not place the terminal in an enclosed area where the cooling vents are blocked or impede the flow of air through

the ventilation openings.

• Install the terminal so that its position does not interfere with its proper ventilation. For example, do not place the

terminal on a bed, sofa, rug, or similar surface that could block the ventilation openings.

• Install the terminal so that there is a minimum of two inches of space between surrounding surfaces and the top,

left, and right sides of the terminal to ensure proper ventilation.

• Install the terminal away from heat sources such as radiators, heat registers and stoves. Installation of the terminal

near consumer electronics devices, such as stereo receiver/amplifiers and televisions, is permitted as long as the air

surrounding the terminal does not exceed 40º C (104º F).

• Place the terminal on a flat surface not prone to vibration or impact.

• Do not place the terminal on top of another electronic device.

• Do not install the terminal in an area where condensation occurs.

• To prevent the temporary loss of guide data and cause a temporarily non-responding terminal, do not plug the AC

power cord into a switched power outlet.

• For DCX700 North American models, only use power supplies with Motorola part number 524475-034.

FCC Compliance

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

1 2 3 4 5 6 7 8 9 ... 49 50

Keine Kommentare

Mediacom HD Digital Adapter Betriebsanweisung Seite 4